Recent Posts

Pages: 1 [2] 3 4 ... 10
11
General Discussion / Re: Hello! New (to me) MRT 125/200
« Last post by kevin..in on January 14, 2018, 01:17:57 AM »
after a bit of faffing this week bike is finally finished and I rode it yesterday, it's actually quite good.
the delay was caused by finding a decent handful of beach sand in the fuel tank!!!
12
General Discussion / Re: RS3 125 Valve Clearances & Workshop Manual?
« Last post by bluerob on January 12, 2018, 02:18:25 AM »
Thank you, all sorted.
13
General Discussion / RS3 125 Poor Running & Carb Settings?
« Last post by bluerob on January 12, 2018, 02:18:09 AM »
Hi all,

RS3 125, will only run with a bit of choke, when running and left to idle the revs increase & decrease. Release the choke and it dies. I've altered the idle up but revs its nuts off, but when the choke is released it still dies.

Use the throttle and it sounds like it is being flooded then will rev at high RPM.

Any ideas? Does anyone have the correct carb settings?
14
General Discussion / Re: Hello! New (to me) MRT 125/200
« Last post by kevin..in on January 05, 2018, 05:34:20 AM »
Well the bike is all rebuilt and running now, it's the boys b'day today and the bike is being presented tomorrow.
He knows nothing about it. I'm excited for him!!!!
15
General Discussion / Re: 125 MET Pro Black Series
« Last post by Marcel125 on January 04, 2018, 04:03:45 AM »
On the left hand side plastic, under it is the CDI and other electricals. Next to the CDI you with find a black wire connected to a yellow and black one. Once unplugged the cdi is derestricted. Along with that remove the air filter to take out the plastic restricor plate and lastly to derestrict it completely remove the EGR system from the exhaust and air box
16
General Discussion / Re: RS3 125 Valve Clearances & Workshop Manual?
« Last post by Marcel125 on January 04, 2018, 04:00:23 AM »
0.10 for intake side and 0.20 for exhaust side. Make sure itís on the intake strike when adjusting/measuring the intake clearance and visa versa
17
General Discussion / RS3 125 Valve Clearances & Workshop Manual?
« Last post by bluerob on December 29, 2017, 06:17:32 AM »
Hi,

Does anyone have details of what the valve clearances should be for the RS3 125?

Also anyone found a workshop manual for the same bike?

Cheers
20
General Discussion / Re: Hello! New (to me) MRT 125/200
« Last post by swampylancer on December 23, 2017, 07:02:24 AM »
What bike the 150 head off as was looking at the 180 kit for my 125
Pages: 1 [2] 3 4 ... 10